After a chemical fire, a public statement about air quality rarely answers every question an affected resident needs to ask. What chemicals were measured? Where were the instruments? Did they operate while the smoke passed the house? Were the results available when officials made their decisions? Those questions call for the underlying records, read alongside the person’s own account of where they were and what happened.
This guide identifies the records that can help answer those questions, explains how to request them, and distinguishes evidence of a release from proof of an individual injury. The Smitty’s Supply fire in Roseland began on August 22, 2025. It is a historical example of why these distinctions matter, not a notice of a current fire or evacuation.
- What the Smitty’s and ASPECT records show
- How to read an air-monitoring result
- Records and their likely custodians
- Federal and Louisiana request language
- Personal evidence and injury claims
What the Smitty’s and ASPECT records show
In an August 22, 2025 announcement, EPA and LDEQ reported that monitoring results at that stage were either nondetects or below health-based or actionable thresholds. The agencies described monitoring inside and outside a one-mile evacuation zone. That dated statement should be evaluated against the measurements available then; it does not establish conditions at every address throughout the incident.
A separate June 23, 2026 EPA inspector-general report examined the chemical-sensing capability of ASPECT, EPA’s airborne monitoring system. The report found that chemical results intended to be available in about five minutes instead generally required approximately a week of manual analysis. It described ASPECT as a screening tool to identify areas for more detailed ground monitoring. EPA agreed with the recommendations; corrective work remained pending in that report. Its findings concern the system’s performance and do not decide whether a particular resident suffered an injury.
Ames Alexander’s November 16, 2026 investigation, published by WIRED with Floodlight, reports a dispute over interpretation of Smitty’s flight data. That dispute makes the original measurements, analysis methods, subsequent revisions, and dates of communication especially important. A later interpretation should be compared with the original dataset and the scope of the original analysis before anyone draws conclusions about exposure.
Start with EPA’s Smitty’s response record and the LDEQ document system. Keep the document’s own date with each result. An older response update is evidence of what the agency reported at that time, not proof of today’s cleanup status.
A nondetect is a result with limits
A nondetect ordinarily means that the analysis did not identify the target substance above the method’s detection limit in that sample. It does not mean that every chemical was absent. ATSDR’s guidance for evaluating sampling data calls for examination of sampling objectives, representativeness, and quality before the data are used to assess exposure.
The distinction becomes important when the detection limit is higher than the health comparison value. ATSDR gives an example in which a nondetect cannot establish that the concentration was below that comparison value. The correct response is to examine the method and its limits, not to convert the nondetect into either a zero or a positive measurement.
- Chemical and medium: Identify the substances the method looked for and whether the measurement concerns air, water, soil, or another material. A total-organic-vapor reading may not identify each individual compound.
- Place and time: Match collection locations and start and end times to the person’s location. Note the time zone, wind observations, monitoring gaps, and whether a sample was collected before, during, or after the relevant period.
- Units and averaging period: Keep the reported units, detection and reporting limits, and averaging duration. A short reading and a day-long average answer different questions.
- Comparison value: Identify the exact threshold used, its source, exposure duration, and purpose. Ask whether it is an emergency screening value, a regulatory standard, or another benchmark.
- Quality and revisions: Retain qualifiers, calibration records, blanks, validation findings, and later corrections. A chart without those details may be insufficient to evaluate a disputed result.
An airborne reading, a ground monitor, and a personal exposure history are different forms of evidence. They may complement one another, but they are not interchangeable. Qualified environmental and medical professionals may be needed to evaluate whether the measurements support a conclusion about a particular person. The presence of a hazardous substance alone does not establish the dose received or the cause of a medical condition.
Records to obtain and where to look
This is a request checklist, not a claim that every listed record exists in every incident. Request the records from the agency or other organization that actually holds them.
Scroll horizontally to see all columns. Use the arrow keys when the table is focused.
| Record | Likely source | Question it helps answer |
|---|---|---|
| Deployment requests, flight logs, flight paths, raw chemical-sensing data, analysis outputs and revisions | EPA response staff and ASPECT program; contractors through the agency where applicable | What was collected, what was analyzed, and when did responders receive it? |
| Ground-monitor logs, instrument identifiers, locations, target substances and operating gaps | EPA, LDEQ, local responders, or the contractor conducting the monitoring | Does the monitoring cover the relevant location and time? |
| Sampling plans, laboratory reports, chain-of-custody forms, detection limits and validation packages | The sampling agency and laboratory; privately commissioned records through their custodian | What was tested, how was it handled, and what limitations accompany the result? |
| Weather observations and any plume modeling with assumptions and inputs | Responding agencies and the identified weather or modeling provider | What conditions informed the response, and what is measured rather than modeled? |
| Incident reports, situation reports, evacuation or shelter notices and lifting orders | Parish emergency management, responding fire department, sheriff, municipality, state police or other issuing agency | Which official acted, when, and on what information? |
| Facility submissions, release notifications, inspections, permits and enforcement records | LDEQ; EPA for federal records; facility for its own retained documents | What did the facility report, and what did regulators document? |
| Public statements, supporting measurements and communications about interpretation | The agency issuing the statement and participating agencies holding copies | Which data supported the statement and whether later information changed it? |
| Cleanup plans, property sampling, access agreements and disposal records | Agency supervising the work, property owner and cleanup contractor | What was removed or tested at a particular property, and under what conditions? |
An agency’s possession of a contractor’s report and the contractor’s own files are separate matters. A public-records request reaches records subject to the applicable disclosure law; it is not a subpoena to every private party. Counsel can address preservation demands, inspections, discovery, and protective arrangements for records that cannot be obtained through a public request.
Request existing records from the right government office
Use federal FOIA for EPA records and Louisiana’s Public Records Law for state and local records. R.S. 44:31 establishes Louisiana access rights subject to statutory exceptions. R.S. 44:32 addresses the custodian’s duties and copies. Neither route makes every record public regardless of an applicable exemption.
Describe a defined incident, facility, location, date range, and record category. Separate the period when measurements were collected from the later period when they may have been reviewed. Request existing electronic files where available, including the field definitions needed to understand them. A demand that an agency explain whether a fire caused an illness is not a request for an existing record.
EPA request: monitoring and later analysis
Submit through EPA’s current FOIA process. The agency identifies its Public Access Link as the preferred electronic route and explains that FOIA does not require it to conduct research or create records. Adapt this language to the incident and the records actually needed:
“Under the Freedom of Information Act, I request existing records concerning [incident, facility and location] for [collection dates], together with subsequent analyses or revisions through [end date]. Please include deployment requests and flight logs; available raw and processed airborne chemical-monitoring files; ground-monitoring and laboratory results; sampling locations and timestamps; target-chemical lists; detection and reporting limits; calibration and quality-review records; and communications transmitting or revising the monitoring findings. Please search the relevant regional response office and ASPECT program records. I request the existing electronic format where available, including data dictionaries or other existing documentation needed to interpret the files. Please identify any records withheld and the applicable exemption, and release reasonably segregable nonexempt portions. Please notify me before fees exceed [amount].”
Ask for rolling production if records can be released in separate groups. Save the request, acknowledgment, tracking number, correspondence, and final determination. A general FOIA response period should not be mistaken for a guarantee that every responsive file will be delivered within that period. Review the determination’s appeal instructions if records are withheld.
LDEQ or local-agency request: incident and sampling records
Search LDEQ’s EDMS first by facility and agency-interest number where known. For missing records, use the online request form linked from LDEQ’s Information & Records page. Its instructions distinguish the online form from its paper form; do not email the paper form. For a parish or municipal agency, address the request to that agency’s records custodian.
“Under Louisiana’s Public Records Law, I request existing records in your custody concerning [incident, facility and location] from [start date] through [end date]: incident and situation reports; monitoring and sampling plans; field and laboratory results with locations, timestamps, units and qualifiers; quality-assurance and calibration records; facility release notifications; public notices and evacuation or shelter decisions; and records supporting or revising public air-quality statements. Please provide existing electronic copies where available. If another office holds any identified category, please identify that office if known. For withheld material, please state the legal basis and provide nonexempt portions. Please notify me before reproduction charges exceed [amount].”
Retain the original request and responses. Louisiana’s R.S. 44:35 provides a judicial enforcement route in specified circumstances. Its timing rules address determinations and reasonable estimates as well as access; they should not be reduced to a promise that every request must be fully produced within five business days.
Preserve the evidence tied to the person and property
- Personal chronology: Record where you were, when smoke or odors were observed, time spent indoors or outdoors, evacuation movements, and when symptoms began. Distinguish direct observations from information learned later.
- Original images and communications: Keep unedited photos and videos with their original files and timestamps, alerts, messages, and dated notices. Identify the camera’s location. Make a backup before editing a copy.
- Medical and expense records: Keep treatment and ambulance records, bills, work absences, lodging, transportation, cleaning and replacement expenses. Give treating clinicians an accurate exposure history; a lawyer’s evidence checklist is not a medical diagnosis.
- Property and samples: Photograph conditions from a safe location. Preserve cleanup estimates, contractor communications, access agreements and laboratory paperwork. Arrange sampling through qualified professionals when appropriate. Do not enter a restricted area or handle potentially contaminated material to gather evidence.
- Statements and releases: Save communications with the facility, insurers, contractors and agencies. Read any release or access agreement before signing; permission to enter property and settlement of an injury claim can have different consequences.
An agency complaint, a cleanup program, an insurance claim and a civil injury case serve different purposes. Making one report does not necessarily preserve every other remedy or deadline. Review the relevant facts and applicable law promptly rather than waiting for a final environmental report.
For related issues, see our toxic-exposure guidance, our discussion of pollution studies and emissions records, and the industrial-damage settlement checklist. This article is part of Louisiana Legal Research.